Tooling for wire EDM

3R-282.12HP

For mounting Magnum holders in the MacroTwin system. Note: All holders including HP can be mounted.

3R-266.12HP

For manual mounting of Magnum holders in the MacroTwin system. Note: All holders including HP can be mounted

3R-228J

Stone with three ground faces, a reference element and a clearance stone. Together with a surface plate and a dial indicator, 3R-228J is an excellent presetting tool for a modest outlay.

3R-228EI

Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.

3R-216

With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.

3R-216.6

For setting angles on swivelling elements. Angles are set with gauge blocks.

3R-606.2

Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.

3R-206.10

Control ruler for horizontal Macro chucks. One long side ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.

3R-226.6

For horizontal clamping SuperVice and holders in vertical Macro chucks.

3R-262.6

For horizontal mounting of SuperVice and holders in vertical Macro chucks.

3R-232S

For mounting SuperVice, a holder or a fixture directly on the machine table. Note: All holders including HP can be mounted.

C950480

Adapter for System 3R clamping elements with adaptation height 15 / 25 mm: with Unimatic dovetail slide.