Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-203.66
Swivelling element with manual Macro chuck to be mounted onto a Macro chuck. Mecanical locking of the set position. Vernier scale for quick setting in 0.1-degree steps. Note: For angle setting sine ruler 3R-216.6 and gauge block are recommended.
3R-223.3
Used where vertical or horizontal displacement of workpiece or accessory is necessary.
90937
Swivelling element with manual Macro chuck to be mounted onto leveling heads. Mecanical locking of the set position. Vernier scale for quick setting in 0.1-degree steps. Note: For angle setting sine ruler 3R-216.6 and gauge block are recommended.
D-30232
Swivelling element with manual Macro chuck. Display included.
3R-226.6
For horizontal clamping SuperVice and holders in vertical Macro chucks.
3R-262.6
For horizontal mounting of SuperVice and holders in vertical Macro chucks.
3R-232S
For mounting SuperVice, a holder or a fixture directly on the machine table. Note: All holders including HP can be mounted.
3R-200.1J-U
Universal 150 mm reference element, with oval holes, for all machines that have M8 holes in the machine table, 30 to 40 mm from the edge of the table.
3R-200.XJ-X
Reference elements for machines with zero-line table. The length (L), hole spacing (C) and hole edge spacing (B) of the hardened reference elements are matched to the machine in question. Note: When ordering, state machine mark and type.
3R-602.27-1
Chuck adapter with lever for Macro holder in the WEDM system. Note: When mounted on the reference element, the two clamping jaws must be tightened with the same torque, 4 Nm.