Tooling for EDM
397 results for 'Tooling for EDM'
3R-460.83-2
Pneumatic chuck for mounting directly on the machine spindle. All XYZ-references in hardened and ground steel. Note: When ordering state machine make and type.;
3R-410.31-5
Chuck in High Performance version. Five ground surfaces for vertical or horizontal mounting on the machine table.
3R-SP19143
Stainless steel chuck with ground flange Ø22x6 mm for mounting in a fixture or the WEDM system. Axial locking screw with channel for flushing through the electrode.
3R-460.86-2
Pneumatic chuck for mounting directly on the machine spindle. All X/Y/Z references in hardened and ground steel. Note: When ordering state machine make and type.
3R-600.24-4RS
Rust resistant chuck for Macro holder. Mounts on a suitable fixture.
3R-461.1E-GA
Holder with journal , 3R-461.1E-GA Journal Ø10x10 mm. Intended mainly for graphite electrodes. To be mounted on 3R-491E with three MFT4x12 screws and adhesive.
3R-SP19270
Used in combination with 3R-491E when electrode blanks are mounted with adhesive and screws*. Permits mounting in MacroCombi chucks.
3R-652.9
For horizontal mounting of Macro holders. Supplied with drawbar for screw locking.
3R-494-S12x50
Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.
3R-681.71
Hardened reference element with clearance holes for fixing screws. Note: Must be mounted on the workpiece/fixture before it is locked in a chuck.