Tooling for EDM
397 results for 'Tooling for EDM'
3R-600.24-4RS
Rust resistant chuck for Macro holder. Mounts on a suitable fixture.
3R-652.9
For horizontal mounting of Macro holders. Supplied with drawbar for screw locking.
3R-322/50E
Holder with hardened reference part and unhardened electrode mounting part.
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.
3R-690.1-185
Chuck for permanent mounting on the machine table or into a PM press.
3R-690.1-142
Chuck for permanent mounting on the machine table or into a PM press.
3R-494-D12x50
Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.
3R-SP28340
Chuck for permanent mounting in the machine table or into a PM press.