Tooling for EDM
397 results for 'Tooling for EDM'
C522520
Chuck adapter with built-in pneumatic Macro chuck for mounting in C219800.
3R-936-60.38
Reference tables of structurally-stable toughened steel (270-320 HB). Hardened bushes in dead-end holes for 3Refix mandrels Ø20 mm at 100x100 mm modular spacing, as well as M12 tapped mounting holes with 50x50 mm modular spacing. Note: Customised reference tables can be made to order. Note: Hardened reference tables (650-700 HB) can be made to order.
3R-901-10RS
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
3R-901-20E
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
3R-903-20.235
Bushes of hardened spring steel 54 HRC. Outside diameter 23.5mm
3R-901-20RS
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.