Tooling for EDM
397 results for 'Tooling for EDM'
3R-460.83-2
Pneumatic chuck for mounting directly on the machine spindle. All XYZ-references in hardened and ground steel. Note: When ordering state machine make and type.;
3R-410.31-5
Chuck in High Performance version. Five ground surfaces for vertical or horizontal mounting on the machine table.
3R-SP19143
Stainless steel chuck with ground flange Ø22x6 mm for mounting in a fixture or the WEDM system. Axial locking screw with channel for flushing through the electrode.
3R-460.86-2
Pneumatic chuck for mounting directly on the machine spindle. All X/Y/Z references in hardened and ground steel. Note: When ordering state machine make and type.
3R-652.9
For horizontal mounting of Macro holders. Supplied with drawbar for screw locking.
3R-494-D16x50
Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.
3R-322/50E
Holder with hardened reference part and unhardened electrode mounting part.
3R-690.1-185
Chuck for permanent mounting on the machine table or into a PM press.
3R-690.1-142
Chuck for permanent mounting on the machine table or into a PM press.
3R-SP28340
Chuck for permanent mounting in the machine table or into a PM press.