Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-292.66HP
Can be supplemented with 3Ruler accessories. Note: Mounts on an HP mounting head
3R-60.360SA
Compact Rotary Indexing Tables with pneumatic Macro chuck. Indexing 0-360° with smallest step 0.001°. Air connections for open/close, as well as turbo-locking/air-blast cleaning. Supplied with a separate control unit.
D-30206
Pneumatic built-in chucks for Macro holders. Can also be used in milling and grinding operations without high cutting forces.
D-30229-3
Rotation table with Matrix 185 interface. Note: The units are controlled by the machine. The mark and type of the machine must therefore be stated when ordering.
3R-611.60
Unit for operating pneumatic chucks in B-axes. Two functions – open/closed with four seconds delay for air-blast cleaning.
3R-272HP
For manual mounting of SuperVice, a holder or a fixture in the WEDM system. Note: All holders including HP can be mounted. Also fits the ICS system if the clamping jaw (17850-00) is changed.
3R-262HP
For mounting SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
3R-266.5
For mounting SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
3R-200.XJ-X
Reference elements for machines with zero-line table. The length (L), hole spacing (C) and hole edge spacing (B) of the hardened reference elements are matched to the machine in question. Note: When ordering, state machine mark and type.
3R-602.27-1
Chuck adapter with lever for Macro holder in the WEDM system. Note: When mounted on the reference element, the two clamping jaws must be tightened with the same torque, 4 Nm.