Tooling for EDM
397 results for 'Tooling for EDM'
3R-936-85.40
Reference tables of structurally-stable toughened steel (270-320 HB). Hardened bushes in dead-end holes for 3Refix mandrels Ø20 mm at 100x100 mm modular spacing, as well as M12 tapped mounting holes with 50x50 mm modular spacing. Note: Customised reference tables can be made to order. Note: Hardened reference tables (650-700 HB) can be made to order.
3R-SP19143
Stainless steel chuck with ground flange Ø22x6 mm for mounting in a fixture or the WEDM system. Axial locking screw with channel for flushing through the electrode.
3R-903-20-315
Bushes of hardened spring steel 54 HRC. Outside diameter 31.5 mm
3R-903-20-3175
Bushes of hardened spring steel 54 HRC. Outside diameter 31.75 mm
3R-SP19270
Used in combination with 3R-491E when electrode blanks are mounted with adhesive and screws*. Permits mounting in MacroCombi chucks.
3R-SP19269
Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.
3R-322/50E
Holder with hardened reference part and unhardened electrode mounting part.
3R-600.24-4RS
Rust resistant chuck for Macro holder. Mounts on a suitable fixture.
3R-494-S12x50
Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.