Tooling for EDM
397 results for 'Tooling for EDM'
3R-322/50E
Holder with hardened reference part and unhardened electrode mounting part.
3R-690.1-185
Chuck for permanent mounting on the machine table or into a PM press.
3R-690.1-142
Chuck for permanent mounting on the machine table or into a PM press.
3R-SP28340
Chuck for permanent mounting in the machine table or into a PM press.
3R-SP28395
Chuck for permanent mounting in the machine table or into a PM press.
3R-SP28219
Chuck for permanent mounting in the machine table or into a PM press.
3R-491E
For copper or graphite electrodes. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.
3R-SP19269
Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).