Tooling for EDM
397 results for 'Tooling for EDM'
3R-494-S32x50
Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.
3R-494-S40x50
Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.
3R-494-32x22x50
Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.
3R-322/50E
Holder with hardened reference part and unhardened electrode mounting part.
3R-321-4x90º
Hydraulic chuck for mounting on machine spindle with Midi system.
3R-321.2-4x90°
Hydraulic chuck with set screws, for mounting on a lathe taper.
3R-321.46
Manual hydraulic chuck for vertical or horizontal mounting on the machine table.
3R-463/5033
For mounting MacroJunior holders in the Mini system. Axial locking screw with channel for flushing through the electrode. Note: For EDM machining only.
3R-322/25S
Holder with hardened reference part and unhardened electrode mounting part.
3R-690.1-110
Chuck for permanent mounting on the machine table or into a PM press.
3R-SP28219
Chuck for permanent mounting in the machine table or into a PM press.