Tooling for EDM
397 results for 'Tooling for EDM'
3R-460.83-2
Pneumatic chuck for mounting directly on the machine spindle. All XYZ-references in hardened and ground steel. Note: When ordering state machine make and type.;
3R-410.31-5
Chuck in High Performance version. Five ground surfaces for vertical or horizontal mounting on the machine table.
![Chuck in HighPerformance version. Five ground surfaces for vertical or horizontal mounting on the machine table.](https://apiecat.gfms.com/medias/3R-460.31-5.jpg?context=bWFzdGVyfGltYWdlc3wyOTg4NDN8aW1hZ2UvanBlZ3xhRFE1TDJnMVpDODRPREE0TVRVME1UWTVNemMwTHpOU0xUUTJNQzR6TVMwMUxtcHdad3xkZWUwMGJlNTM0MGE3OTI4YzNhNTVkYjkxNDQyYThlZGUzMjRmZWQ4NWZjZGRkMTVlMzg0MTRkOThkOGU0ZjQy)
3R-460.31-5
Chuck in HighPerformance version. Five ground surfaces for vertical or horizontal mounting on the machine table.
3R-690.1-185
Chuck for permanent mounting on the machine table or into a PM press.
3R-690.1-142
Chuck for permanent mounting on the machine table or into a PM press.
3R-SP28268
Chuck for permanent mounting in the machine table or into a PM press.
3R-690.1-110
Chuck for permanent mounting on the machine table or into a PM press.
3R-SP28219
Chuck for permanent mounting in the machine table or into a PM press.
3R-491E-HP
Top and bottom faces parallel-ground to within 0.002 mm. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.