Tooling for EDM
397 results for 'Tooling for EDM'
3R-SP20753
Nipple for manual operation by air gun of pneumatic chucks with R1/8” connecting thread.
3R-SP19270
Used in combination with 3R-491E when electrode blanks are mounted with adhesive and screws*. Permits mounting in MacroCombi chucks.
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
3R-600.24-4RS
Rust resistant chuck for Macro holder. Mounts on a suitable fixture.
C219650
Pneumatic chuck with built-in Macro chuck. Intended mainly for measuring machines. The following pallets can be mounted in GPS240 by means of C 219 650: Macro 54x54 mm and Macro 70x70 mm
3R-6.600-VHS
For clamping in a horizontal or vertical Macro chuck. Flushing via the spindle or an external flushing connection.