Tooling for powder compacting
45 results for 'Tooling for powder compacting'
3R-901-10PM-TX
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
3R-680.27-150
Manual chuck for permanent mounting in spindle of powder press machine.
90803.60
Pneumatic chuck for permanent mounting in spindle of powder press.
3R-600.17-60
Pneumatic chuck for permanent mounting in spindle of powder press machine.
D-20173
Manual chuck for permanent mounting in spindle of powder press machine.
D-20158-BASE
This fixture enables adjustment of punches within metal powder compacting by Macro system. The fixture is a stand-alone unit. It is possible to replace the indicators with electrical sensors. Free access from underneath, to access fixation-screws for the pallets.
90909
Alignment and control tool for the Macro + 3Refix system in PM. Alignment is rough but helps reduce assembly time before final verification and alignment with verification tools. Also to be used to check parallelism between punch levels versus die-plate-level.