Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-239.11
Movable jaws for mounting two rectangular workpieces at the same time. Detachable Z-support tabs ensure simple setting-up.
3R-294.2
For clamping workpieces up to 50 mm. Mounts on 3R-237.2, 3R-294, 3R-292.66HP or a ruler in the 3Ruler system or Macropallet 54x54 mm.
3R-206.10
Control ruler for horizontal Macro chucks. One long side ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
3R-220.3
Unit with double-insulated reference contacts for wire alignment.
D-30229-3
Rotation table with Matrix 185 interface. Note: The units are controlled by the machine. The mark and type of the machine must therefore be stated when ordering.
3R-611.60
Unit for operating pneumatic chucks in B-axes. Two functions – open/closed with four seconds delay for air-blast cleaning.