Tooling for EDM
397 results for 'Tooling for EDM'
3R-460.86-2
Pneumatic chuck for mounting directly on the machine spindle. All X/Y/Z references in hardened and ground steel. Note: When ordering state machine make and type.
3R-410.1-M
For mounting on the machine spindle or in a fixture on the machine table.
3R-460.34
For mounting in the machine spindle by means of 3R-A11489, or on the machine table by means of 3R-A19724 or alternatively 3R-A21944, or in a fixture.
3R-400.34
For mounting in the machine spindle by means of 3R-A11489, or on the machine table by means of 3R-A19724 or alternatively 3R-A21944, or in a fixture.
3R-322/50E
Holder with hardened reference part and unhardened electrode mounting part.
3R-690.1-185
Chuck for permanent mounting on the machine table or into a PM press.
3R-690.1-142
Chuck for permanent mounting on the machine table or into a PM press.
3R-SP28340
Chuck for permanent mounting in the machine table or into a PM press.
3R-SP28395
Chuck for permanent mounting in the machine table or into a PM press.
3R-461.1E-GA
Holder with journal , 3R-461.1E-GA Journal Ø10x10 mm. Intended mainly for graphite electrodes. To be mounted on 3R-491E with three MFT4x12 screws and adhesive.
3R-SP19270
Used in combination with 3R-491E when electrode blanks are mounted with adhesive and screws*. Permits mounting in MacroCombi chucks.
3R-SP19269
Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.