Tooling for EDM

3R-600.24-4RS

Rust resistant chuck for Macro holder. Mounts on a suitable fixture.

3R-410.31-5

Chuck in High Performance version. Five ground surfaces for vertical or horizontal mounting on the machine table.

3R-SP19143

Stainless steel chuck with ground flange Ø22x6 mm for mounting in a fixture or the WEDM system. Axial locking screw with channel for flushing through the electrode.

3R-460.86-2

Pneumatic chuck for mounting directly on the machine spindle. All X/Y/Z references in hardened and ground steel. Note: When ordering state machine make and type.

3R-6.600-VHS

For clamping in a horizontal or vertical Macro chuck. Flushing via the spindle or an external flushing connection.

3R-659.16-P

Chuck for collets ER16.

3R-467.9-1

For horizontal mounting of MacroJunior holders. Screw locking. Note: For EDM machining only..

3R-491E

For copper or graphite electrodes. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.

3R-491E-HP

Top and bottom faces parallel-ground to within 0.002 mm. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.

3R-461.1E-GA

Holder with journal , 3R-461.1E-GA Journal Ø10x10 mm. Intended mainly for graphite electrodes. To be mounted on 3R-491E with three MFT4x12 screws and adhesive.

3R-SP19270

Used in combination with 3R-491E when electrode blanks are mounted with adhesive and screws*. Permits mounting in MacroCombi chucks.

3R-SP19269

Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.