Tooling for EDM

3R-691.1-185

Note: Not self carrying, requires extra support.

3R-691.1-220

Note: Not self carrying, requires extra support.

3R-691.1-260

Note: Not self carrying, requires extra support.

3R-695.2-110

Note: In automation the gripper has to grip on the pallet and not on the drawbar.

3R-695.2-142

Note: In automation the gripper has to grip on the pallet and not on the drawbar.

3R-695.2-185

Note: In automation the gripper has to grip on the pallet and not on the drawbar.

3R-695.2-220

Note: In automation the gripper has to grip on the pallet and not on the drawbar.

3R-695.2-260

Note: In automation the gripper has to grip on the pallet and not on the drawbar.

3R-SP19269

Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.

3R-461-8.8-HP

Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).

3R-465.1E-A

The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.

3R-469-10

Chuck for collets ETS10.