Tooling for EDM
397 results for 'Tooling for EDM'
3R-322/50E
Holder with hardened reference part and unhardened electrode mounting part.
3R-SP28395
Chuck for permanent mounting in the machine table or into a PM press.
3R-SP28268
Chuck for permanent mounting in the machine table or into a PM press.
3R-690.1-110
Chuck for permanent mounting on the machine table or into a PM press.
3R-SP28219
Chuck for permanent mounting in the machine table or into a PM press.
3R-465-LE
For round electrodes Ø4-8 mm or square < 8x18 mm, and with maximum height 30 mm.
3R-494-D10x50
Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.
3R-681.71
Hardened reference element with clearance holes for fixing screws. Note: Must be mounted on the workpiece/fixture before it is locked in a chuck.