Tooling for EDM
397 results for 'Tooling for EDM'
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.
3R-600.24-4RS
Rust resistant chuck for Macro holder. Mounts on a suitable fixture.
3R-494-D16x50
Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.
3R-494-D22x50
Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.
3R-SP28395
Chuck for permanent mounting in the machine table or into a PM press.
3R-SP28268
Chuck for permanent mounting in the machine table or into a PM press.
3R-771.7
Reference kit for users who want to make their own pallets or fixtures.
3R-776.1-2
For alignment of the Dynafix references. With ground reference rulers, hole and surface.