Tooling for parts production
417 results for 'Tooling for parts production'
3R-SSP115-BASE
For both pneumatic and manual chucks. This stand alone unit in combination with individual drawbars or drawbar kits, able to cover MacroJunior, Macro, MacroMagnum and Dynafix. Note: Require drawbars with bayonet interface similar to 3R-605.1.
3R-TXXXX
Taper attachment for mounting chucks in taper spindles. Note: Manufactured on request. State machine type, taper (1), drawbar thread (2) and which 3R chuck is to be mounted.
3R-A21944
For vertical or horizontal mounting of 3R-400.34, 3R-460.34 and 3R-600.24-S on the machine table. Intended for milling. Note: Chuck to be ordered separately.
3R-A19724
For mounting of 3R-400.34, 3R-460.34 and 3R-600.24-S on machine table. Note: Chuck to be ordered separately.
C250310
For direct installation on a machine table. Mounting holes to be drilled at installation.
C250350
For direct installation on a machine table. Mounting holes to be drilled at installation.
3R-682.600-A
Chuck adapter with built-in pneumatic Macro chuck for mounting in 3R-680.10-2A.
3R-682.600-RS
Chuck adapter with built-in Pneumatic Macro chuck.
90964
From MacroMagnum into Macro system. Chuck adapter with built-in Macro chuck.
3R-600.24-4RS
Rust resistant chuck for Macro holder. Mounts on a suitable fixture.
3R-6.600-VHS
For clamping in a horizontal or vertical Macro chuck. Flushing via the spindle or an external flushing connection.