Tooling for powder compacting
45 results for 'Tooling for powder compacting'
D-20198-DZxx
Requires computer etc by D-20189-BASE. To be used in combination with punch unit D-20198-Zxx.
3R-901-20PM-TX
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
3R-901-10PM-TX
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
3R-SP33230
From Matrix 142 into Macro system. Chuck adapter with built-in Macro chuck.
3R-692.8-142
In combination with 3R-692.7-110 and 3R-692.7-142 to enable lift by crane.
3R-692.8-220
In combination with 3R-692.7-185 and 3R-692.7-220 to enable lift by crane.
D-20158-BASE
This fixture enables adjustment of punches within metal powder compacting by Macro system. The fixture is a stand-alone unit. It is possible to replace the indicators with electrical sensors. Free access from underneath, to access fixation-screws for the pallets.
D-20198-ZXX
Tool to establish Z-distance in combination with either 3Refix or Matrix 142 pallet. This unit requires additional tool. It is possible to apply electrical or mechanical indicators while measuring top surface. Note: Linear probe is not included.
90238
Fixture for punch on Macro, in order to wire-cut a through hole within Ø20 mm.