Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-228E
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate.
3R-228.1
Surface plate with reference stops, a mounting stone with bushings and holes for mounting a chuck/reference element and through holes for mounting on the surface plate, and a check stone. A dial indicator is required.
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
3R-216
With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.
3R-216.6
For setting angles on swivelling elements. Angles are set with gauge blocks.
3R-262.6
For horizontal mounting of SuperVice and holders in vertical Macro chucks.
3R-232S
For mounting SuperVice, a holder or a fixture directly on the machine table. Note: All holders including HP can be mounted.
3R-680.24RS
Chuck for MacroMagnum holder. For permanent mounting on the machine spindle or table. Note: Master 3R-606.1 or 3R-686.1-HD required at installation.
3R-422.2
Chuck adapter with axial locking screw for MacroJunior holders in the WEDM system.
3R-466.40RS
Chuck adapter, stainless steel, for MacroJunior holders in the Macro system. Axial locking screw.
3R-252.1
Chuck adapter with dual hydraulic chambers for Mini holders in the WEDM-system.