Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-228U
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate and a dial indicator.
90945.01
Pneumatic chuck for permanent mounting on the machine table.
D-30215
Angle tool, Macro with vernier scale -90º to 0 to +90º. Note: Macro chuck is required on the machine table for clamping.
3R-217-1
Manual Macro chuck. For vertical or horizontal mounting on the machine table, or alternatively the WEDM system with the aid of 3R-SP6435.
3R-201.5
Mounts directly on the machine table. For vertical mounting of a Macro chuck or short reference element in the machine.
3R-228E
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate.
3R-228.1
Surface plate with reference stops, a mounting stone with bushings and holes for mounting a chuck/reference element and through holes for mounting on the surface plate, and a check stone. A dial indicator is required.
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
3R-216
With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.
3R-216.6
For setting angles on swivelling elements. Angles are set with gauge blocks.
3R-606.2
Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.