Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-213.4
Vice for mounting rectangular workpieces up to 25 mm in the Mini system.
3R-272HP
For manual mounting of SuperVice, a holder or a fixture in the WEDM system. Note: All holders including HP can be mounted. Also fits the ICS system if the clamping jaw (17850-00) is changed.
3R-226.6
For horizontal clamping SuperVice and holders in vertical Macro chucks.
3R-262.6
For horizontal mounting of SuperVice and holders in vertical Macro chucks.
3R-232S
For mounting SuperVice, a holder or a fixture directly on the machine table. Note: All holders including HP can be mounted.
C950480
Adapter for System 3R clamping elements with adaptation height 15 / 25 mm: with Unimatic dovetail slide.
3R-216.6
For setting angles on swivelling elements. Angles are set with gauge blocks.
3R-606.2
Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
3R-206.10
Control ruler for horizontal Macro chucks. One long side ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
3R-220.3
Unit with double-insulated reference contacts for wire alignment.