Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-272HP
For manual mounting of SuperVice, a holder or a fixture in the WEDM system. Note: All holders including HP can be mounted. Also fits the ICS system if the clamping jaw (17850-00) is changed.
3R-262HP
For mounting SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
3R-266.4
For manual mounting of SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
3R-266.5
For mounting SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
3R-282.12HP
For mounting Magnum holders in the MacroTwin system. Note: All holders including HP can be mounted.
3R-266.12HP
For manual mounting of Magnum holders in the MacroTwin system. Note: All holders including HP can be mounted
3R-223
Used where vertical or horizontal displacement of workpiece or accessory is necessary.
3R-203.66
Swivelling element with manual Macro chuck to be mounted onto a Macro chuck. Mecanical locking of the set position. Vernier scale for quick setting in 0.1-degree steps. Note: For angle setting sine ruler 3R-216.6 and gauge block are recommended.
3R-223.3
Used where vertical or horizontal displacement of workpiece or accessory is necessary.
90937
Swivelling element with manual Macro chuck to be mounted onto leveling heads. Mecanical locking of the set position. Vernier scale for quick setting in 0.1-degree steps. Note: For angle setting sine ruler 3R-216.6 and gauge block are recommended.