Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-237.2
For fixture, workpiece or 3R-239.2, 3R-239.3, 3R-294.1, 3R-294.2, 3R-294.6 and 3R-402.1.
3R-WP1
Enables automatic changing of 3R-206.10, 3R-208.6, 3R-266.5, 3R-622.6 or customer-made fixtures.
3R-239-XXX
The rulers are available in various lengths (-XXX), to match different machines. The cross-section is matched to the length to ensure optimal stability.
3R-239.1
Movable jaws of SuperVice design provide a wide clamping range for rectangular workpieces. Detachable Z-support tabs ensure simple setting-up.
3R-239-XXX-D
Double-sided rulers are available in various lengths (-XXX), to match different machines. The cross-section is matched to the length to ensure optimal stability. With these rulers, accessories can be clamped on both sides of the ruler.
3R-294.1
For clamping workpieces up to 17 mm. Mounts on 3R-237.2, 3R-294, 3R-292.66HP or rulers in the 3Ruler system.
3R-216.6
For setting angles on swivelling elements. Angles are set with gauge blocks.
3R-606.2
Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.