Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-239.1
Movable jaws of SuperVice design provide a wide clamping range for rectangular workpieces. Detachable Z-support tabs ensure simple setting-up.
3R-239-XXX-D
Double-sided rulers are available in various lengths (-XXX), to match different machines. The cross-section is matched to the length to ensure optimal stability. With these rulers, accessories can be clamped on both sides of the ruler.
3R-292.66HP
Can be supplemented with 3Ruler accessories. Note: Mounts on an HP mounting head
3R-272HP
For manual mounting of SuperVice, a holder or a fixture in the WEDM system. Note: All holders including HP can be mounted. Also fits the ICS system if the clamping jaw (17850-00) is changed.
3R-262HP
For mounting SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
3R-266.4
For manual mounting of SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
3R-266.5
For mounting SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
3R-282.12HP
For mounting Magnum holders in the MacroTwin system. Note: All holders including HP can be mounted.
3R-223
Used where vertical or horizontal displacement of workpiece or accessory is necessary.