Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-239.24
For clamping thin workpieces. To be fitted together with zero-line support tab.
3R-203
Hydraulic locking of set position. Note: For angle setting, 3R-216 is recommended.
3R-223
Used where vertical or horizontal displacement of workpiece or accessory is necessary.
3R-272HP
For manual mounting of SuperVice, a holder or a fixture in the WEDM system. Note: All holders including HP can be mounted. Also fits the ICS system if the clamping jaw (17850-00) is changed.
3R-262HP
For mounting SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.
3R-282.12HP
For mounting Magnum holders in the MacroTwin system. Note: All holders including HP can be mounted.
3R-606.2
Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.