Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-203.66
Swivelling element with manual Macro chuck to be mounted onto a Macro chuck. Mecanical locking of the set position. Vernier scale for quick setting in 0.1-degree steps. Note: For angle setting sine ruler 3R-216.6 and gauge block are recommended.
3R-223.3
Used where vertical or horizontal displacement of workpiece or accessory is necessary.
3R-60.360X
Compact Rotary Indexing Tables with pneumatic Macro chuck. Indexing 0-360° with smallest step 0.001°. Air connections for open/close, as well as turbo-locking/air-blast cleaning. Note: The units are controlled by the machine.The mark and type of the machine must therefore be stated when ordering.
3R-60.360SA
Compact Rotary Indexing Tables with pneumatic Macro chuck. Indexing 0-360° with smallest step 0.001°. Air connections for open/close, as well as turbo-locking/air-blast cleaning. Supplied with a separate control unit.
D-30206
Pneumatic built-in chucks for Macro holders. Can also be used in milling and grinding operations without high cutting forces.
D-30229-3
Rotation table with Matrix 185 interface. Note: The units are controlled by the machine. The mark and type of the machine must therefore be stated when ordering.
3R-611.60
Unit for operating pneumatic chucks in B-axes. Two functions – open/closed with four seconds delay for air-blast cleaning.
3R-602.27-1
Chuck adapter with lever for Macro holder in the WEDM system. Note: When mounted on the reference element, the two clamping jaws must be tightened with the same torque, 4 Nm.
3R-422.2
Chuck adapter with axial locking screw for MacroJunior holders in the WEDM system.
3R-252.1
Chuck adapter with dual hydraulic chambers for Mini holders in the WEDM-system.