Tooling for EDM
397 results for 'Tooling for EDM'
3R-460.83-2
Pneumatic chuck for mounting directly on the machine spindle. All XYZ-references in hardened and ground steel. Note: When ordering state machine make and type.;
3R-410.31-5
Chuck in High Performance version. Five ground surfaces for vertical or horizontal mounting on the machine table.
3R-SP19143
Stainless steel chuck with ground flange Ø22x6 mm for mounting in a fixture or the WEDM system. Axial locking screw with channel for flushing through the electrode.
3R-460.86-2
Pneumatic chuck for mounting directly on the machine spindle. All X/Y/Z references in hardened and ground steel. Note: When ordering state machine make and type.
3R-491E
For copper or graphite electrodes. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.
3R-491E-HP
Top and bottom faces parallel-ground to within 0.002 mm. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.
3R-SP19270
Used in combination with 3R-491E when electrode blanks are mounted with adhesive and screws*. Permits mounting in MacroCombi chucks.
3R-SP19269
Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.