Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
3R-216
With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.
3R-216.6
For setting angles on swivelling elements. Angles are set with gauge blocks.
3R-606.2
Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
3R-206.10
Control ruler for horizontal Macro chucks. One long side ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
3R-220.3
Unit with double-insulated reference contacts for wire alignment.
3R-239.11
Movable jaws for mounting two rectangular workpieces at the same time. Detachable Z-support tabs ensure simple setting-up.
3R-294.2
For clamping workpieces up to 50 mm. Mounts on 3R-237.2, 3R-294, 3R-292.66HP or a ruler in the 3Ruler system or Macropallet 54x54 mm.
3R-294.1
For clamping workpieces up to 17 mm. Mounts on 3R-237.2, 3R-294, 3R-292.66HP or rulers in the 3Ruler system.
3R-294.6
For mounting four workpieces Ø5-13 mm at the same time. Mounts on 3R-237.2, 3R-294, 3R-292.66HP or a ruler in the 3Ruler system.