Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-218S
Set of three holders and fixing parts enabling 3Point levelling and support (aka 3P). For round and rectangular workpiece.
3R-WP1
Enables automatic changing of 3R-206.10, 3R-208.6, 3R-266.5, 3R-622.6 or customer-made fixtures.
3R-239-XXX
The rulers are available in various lengths (-XXX), to match different machines. The cross-section is matched to the length to ensure optimal stability.
3R-239.1
Movable jaws of SuperVice design provide a wide clamping range for rectangular workpieces. Detachable Z-support tabs ensure simple setting-up.
3R-239-XXX-D
Double-sided rulers are available in various lengths (-XXX), to match different machines. The cross-section is matched to the length to ensure optimal stability. With these rulers, accessories can be clamped on both sides of the ruler.
3R-A239
Clamps of aluminium for mounting a ruler directly on the machine table without reference elements.
3R-203
Hydraulic locking of set position. Note: For angle setting, 3R-216 is recommended.
3R-228E
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate.
3R-228.1
Surface plate with reference stops, a mounting stone with bushings and holes for mounting a chuck/reference element and through holes for mounting on the surface plate, and a check stone. A dial indicator is required.
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.