Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-239-XXX
The rulers are available in various lengths (-XXX), to match different machines. The cross-section is matched to the length to ensure optimal stability.
3R-239.1
Movable jaws of SuperVice design provide a wide clamping range for rectangular workpieces. Detachable Z-support tabs ensure simple setting-up.
3R-239-XXX-D
Double-sided rulers are available in various lengths (-XXX), to match different machines. The cross-section is matched to the length to ensure optimal stability. With these rulers, accessories can be clamped on both sides of the ruler.
3R-225.2
For positioning 3Ruler anywhere on the reference elements. The stops have adjusting screws for accurate alignment.
3R-223
Used where vertical or horizontal displacement of workpiece or accessory is necessary.
3R-203.66
Swivelling element with manual Macro chuck to be mounted onto a Macro chuck. Mecanical locking of the set position. Vernier scale for quick setting in 0.1-degree steps. Note: For angle setting sine ruler 3R-216.6 and gauge block are recommended.
3R-223.3
Used where vertical or horizontal displacement of workpiece or accessory is necessary.
3R-292.23
For clamping a workpiece or fixture on a mounting head. Can be supplemented with 3Ruler accessories.
3R-613.4
Vice for mounting rectangular workpieces 0-25 mm in the Macro system.