Tooling for EDM
397 results for 'Tooling for EDM'
3R-600.24-4RS
Rust resistant chuck for Macro holder. Mounts on a suitable fixture.
3R-460.86-2
Pneumatic chuck for mounting directly on the machine spindle. All X/Y/Z references in hardened and ground steel. Note: When ordering state machine make and type.
3R-410.1-M
For mounting on the machine spindle or in a fixture on the machine table.
3R-460.34
For mounting in the machine spindle by means of 3R-A11489, or on the machine table by means of 3R-A19724 or alternatively 3R-A21944, or in a fixture.
3R-400.34
For mounting in the machine spindle by means of 3R-A11489, or on the machine table by means of 3R-A19724 or alternatively 3R-A21944, or in a fixture.
3R-460.31-5
Chuck in HighPerformance version. Five ground surfaces for vertical or horizontal mounting on the machine table.
3R-652.9
For horizontal mounting of Macro holders. Supplied with drawbar for screw locking.
3R-406.9
For horizontal mounting of MacroJunior holders in the Macro system. Screw locking.
3R-SP19270
Used in combination with 3R-491E when electrode blanks are mounted with adhesive and screws*. Permits mounting in MacroCombi chucks.
3R-SP28219
Chuck for permanent mounting in the machine table or into a PM press.