Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-223
Used where vertical or horizontal displacement of workpiece or accessory is necessary.
3R-203.66
Swivelling element with manual Macro chuck to be mounted onto a Macro chuck. Mecanical locking of the set position. Vernier scale for quick setting in 0.1-degree steps. Note: For angle setting sine ruler 3R-216.6 and gauge block are recommended.
3R-223.3
Used where vertical or horizontal displacement of workpiece or accessory is necessary.
90937
Swivelling element with manual Macro chuck to be mounted onto leveling heads. Mecanical locking of the set position. Vernier scale for quick setting in 0.1-degree steps. Note: For angle setting sine ruler 3R-216.6 and gauge block are recommended.
D-30232
Swivelling element with manual Macro chuck. Display included.
3R-228.1
Surface plate with reference stops, a mounting stone with bushings and holes for mounting a chuck/reference element and through holes for mounting on the surface plate, and a check stone. A dial indicator is required.
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
3R-216
With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.
3R-216.6
For setting angles on swivelling elements. Angles are set with gauge blocks.
3R-606.2
Master for determining the position of vertical Macro chucks. Cylinder ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
3R-206.10
Control ruler for horizontal Macro chucks. One long side ground to the Macro references. Supplied with engraved dimensions in the X-, Y- and Z-directions.
3R-220.3
Unit with double-insulated reference contacts for wire alignment.