Tooling for EDM

3R-659.16-P

Chuck for collets ER16.

3R-659.32-P

Chuck for collets ER32.

3R-659.20-P

Chuck for collets ER20.

3R-460.32

For mounting on a lathe taper.

3R-460.31-5

Chuck in HighPerformance version. Five ground surfaces for vertical or horizontal mounting on the machine table.

3R-460.37

The locking mechanism is operated by a removable handle.

3R-491E-HP

Top and bottom faces parallel-ground to within 0.002 mm. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.

3R-461.1E-GA

Holder with journal , 3R-461.1E-GA Journal Ø10x10 mm. Intended mainly for graphite electrodes. To be mounted on 3R-491E with three MFT4x12 screws and adhesive.

3R-494-D10x50

Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.

3R-494-D12x50

Blanks mounted on MacroJunior holders for the manufacture of electrodes. The stock range is matched to local preferences and ways of working. This applies to electrode materials, different grades of graphite and copper, and to dimensions. Contact your local 3R representative for further information. The System 3R factory can supply holders with factory-mounted copper blanks in sets of ten.

3R-690.1-185

Chuck for permanent mounting on the machine table or into a PM press.

3R-690.1-142

Chuck for permanent mounting on the machine table or into a PM press.