Tooling for EDM
397 results for 'Tooling for EDM'
3R-SP28345
Chuck for permanent mounting in the machine table or into a PM press.
3R-696.1-260
For setting flatness and angular positions. Ground hole for centering.
3R-29.2
Pallet with 16 clearance holes for M6 screws and eight M6 threads. Also works as a control ruler to set location of center.
3R-SP19270
Used in combination with 3R-491E when electrode blanks are mounted with adhesive and screws*. Permits mounting in MacroCombi chucks.
3R-SP19269
Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.
3R-461-8.8-HP
Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).
3R-465.1E-A
The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.
3R-465-LE
For round electrodes Ø4-8 mm or square < 8x18 mm, and with maximum height 30 mm.
3R-322/50E
Holder with hardened reference part and unhardened electrode mounting part.