Tooling for powder compacting
45 results for 'Tooling for powder compacting'
3R-692.8-220
In combination with 3R-692.7-185 and 3R-692.7-220 to enable lift by crane.
D-20158-BASE
This fixture enables adjustment of punches within metal powder compacting by Macro system. The fixture is a stand-alone unit. It is possible to replace the indicators with electrical sensors. Free access from underneath, to access fixation-screws for the pallets.
90909
Alignment and control tool for the Macro + 3Refix system in PM. Alignment is rough but helps reduce assembly time before final verification and alignment with verification tools. Also to be used to check parallelism between punch levels versus die-plate-level.
D-20198-DZxx
Requires computer etc by D-20189-BASE. To be used in combination with punch unit D-20198-Zxx.
D-20198-ZXX
Tool to establish Z-distance in combination with either 3Refix or Matrix 142 pallet. This unit requires additional tool. It is possible to apply electrical or mechanical indicators while measuring top surface. Note: Linear probe is not included.
3R-901-20PM-TX
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
3R-901-10PM-TX
Note: When positioning with 3Refix mandrels –always tighten the expanding mandrel in the R0 hole first.
3R-680.27-150
Manual chuck for permanent mounting in spindle of powder press machine.
90803.60
Pneumatic chuck for permanent mounting in spindle of powder press.
3R-600.17-60
Pneumatic chuck for permanent mounting in spindle of powder press machine.