Tooling for wire EDM
144 results for 'Tooling for wire EDM'
3R-217-1
Manual Macro chuck. For vertical or horizontal mounting on the machine table, or alternatively the WEDM system with the aid of 3R-SP6435.
3R-201.5
Mounts directly on the machine table. For vertical mounting of a Macro chuck or short reference element in the machine.
3R-60.360X
Compact Rotary Indexing Tables with pneumatic Macro chuck. Indexing 0-360° with smallest step 0.001°. Air connections for open/close, as well as turbo-locking/air-blast cleaning. Note: The units are controlled by the machine.The mark and type of the machine must therefore be stated when ordering.
3R-60.360SA
Compact Rotary Indexing Tables with pneumatic Macro chuck. Indexing 0-360° with smallest step 0.001°. Air connections for open/close, as well as turbo-locking/air-blast cleaning. Supplied with a separate control unit.
D-30229-3
Rotation table with Matrix 185 interface. Note: The units are controlled by the machine. The mark and type of the machine must therefore be stated when ordering.
3R-611.60
Unit for operating pneumatic chucks in B-axes. Two functions – open/closed with four seconds delay for air-blast cleaning.
3R-228E
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate.
3R-228.1
Surface plate with reference stops, a mounting stone with bushings and holes for mounting a chuck/reference element and through holes for mounting on the surface plate, and a check stone. A dial indicator is required.
3R-228EI
Mounting stone with bushings and holes for mounting chuck/reference elements. Use together with existing measuring machine or surface plate. Note: 3R-228EI delivers with dial indiactor measuring inch.
3R-216
With magnetic attachments for setting angles on swivelling elements. Angles are set with gauge blocks.