Tooling for EDM

3R-SP18286

Pneumatic chuck for building-in, for example in a fixture, dividing head or B-axis.

3R-SP19047

Pneumatic chuck for building-in, for example in a fixture, dividing head or B-axis.

3R-467.9-1

For horizontal mounting of MacroJunior holders. Screw locking. Note: For EDM machining only..

3R-491E

For copper or graphite electrodes. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.

3R-491E-HP

Top and bottom faces parallel-ground to within 0.002 mm. NOTE: The electrode is installed with screw and adhesive assembly, or alternatively brazing.

3R-461.1E-GA

Holder with journal , 3R-461.1E-GA Journal Ø10x10 mm. Intended mainly for graphite electrodes. To be mounted on 3R-491E with three MFT4x12 screws and adhesive.

3R-SP19270

Used in combination with 3R-491E when electrode blanks are mounted with adhesive and screws*. Permits mounting in MacroCombi chucks.

3R-SP19269

Used in combination with 3R-491E when soldering round (<50 mm) or square (<40 mm) copper blanks. Permits mounting in MacroCombi chucks.

3R-461-8.8-HP

Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).

3R-465.1E-A

The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.

3R-469-10

Chuck for collets ETS10.

3R-469-16

Chuck for collets ER16.