Tooling for EDM

3R-13.321

Holder with hardened reference part Ø20 mm for mounting square and flat electrodes.

3R-US90-601

Fixed index positions at 0, 30, 45, 60 and 90 degrees. Other angles are set with a sine rule.

C810710

For controlling pneumatic chucks C217100 and C219000.

3R-461-8.8-HP

Upper and lower faces ground parallel within 0.002 mm. Locating pin Ø8.8 mm (0/0.05 mm).

3R-658.2E-S

Unhardened holder for flat electrodes with max width 30 mm. To be mounted on 3R-651.7E-S, 3R-651.7E-XS or 3R-651.7E-P.

3R-658.4E-S

Unhardened holder for square or round electrodes, max 30 mm. To be mounted on 3R-651.7E-S, 3R-651.7E-XS or 3R-651.7E-P.

3R-651.13

Hardened holder for square electrodes max 30 mm.

3R-461.1E-GA

Holder with journal , 3R-461.1E-GA Journal Ø10x10 mm. Intended mainly for graphite electrodes. To be mounted on 3R-491E with three MFT4x12 screws and adhesive.

3R-465.1E-A

The taper is machined suitably for attaching very small electrodes. To be mounted on 3R-491E with three screws MFT4x12.

3R-465-LE

For round electrodes Ø4-8 mm or square < 8x18 mm, and with maximum height 30 mm.

3R-656.2-P

For measuring centre holes.

3R-3.321-2

For measuring centre holes.