Tooling for EDM

3R-600.24RS

Rust resistant manual chuck designed for permanent mounting.

3R-600.20

For mounting on the machine spindle with 3R-A3620 or on a lathe taper with centring ring 3R-612.6.

3R-410.31-5

Chuck in High Performance version. Five ground surfaces for vertical or horizontal mounting on the machine table.

3R-SP19143

Stainless steel chuck with ground flange Ø22x6 mm for mounting in a fixture or the WEDM system. Axial locking screw with channel for flushing through the electrode.

3R-400.34

For mounting in the machine spindle by means of 3R-A11489, or on the machine table by means of 3R-A19724 or alternatively 3R-A21944, or in a fixture.

3R-400.24-11

For mounting on machine spindle.

3R-680.24-S

Low profile pneumatic chuck for permanent mounting on the machine spindle or table. Note: Master pallet 3R-606.1 or 3R-686.1-HD is required at installation.

3R-680.24-V

Manual vibration-damped table chuck.

3R-600.23-S

Cast chuck with mounting flange for mounting on the machine spindle or in a fixture.

3R-SP15055

Cast chuck with ground flange for installation in fixture/plate.

3R-600.24-S

Cast chuck with ground back face for mounting on the machine spindle with 3R-A11489 or in a fixture on the machine table.

3R-610.21

Three ground faces for vertical or horizontal mounting on the machine table.