Tooling for powder compacting

45 results for 'Tooling for powder compacting'

D-20158-BASE

This fixture enables adjustment of punches within metal powder compacting by Macro system. The fixture is a stand-alone unit. It is possible to replace the indicators with electrical sensors. Free access from underneath, to access fixation-screws for the pallets.

Alignment and control tool for the Macro + 3Refix system in PM. Alignment is rough but helps reduce assembly time before final verification and alignment with verification tools. Also to be used to check parallelism between punch levels versus die-plate-level.

Alignment tool & control Z-distance, Macro PM

90909

Alignment and control tool for the Macro + 3Refix system in PM. Alignment is rough but helps reduce assembly time before final verification and alignment with verification tools. Also to be used to check parallelism between punch levels versus die-plate-level.

Requires computer etc by D-20189-BASE.
To be used in combination with punch unit D-20198-Zxx.

Die unit for Z-distance

D-20198-DZxx

Requires computer etc by D-20189-BASE. To be used in combination with punch unit D-20198-Zxx.

Tool to establish Z-distance in combination with either 3Refix or Matrix 142 pallet. This unit requires additional tool.
It is possible to apply electrical or mechanical indicators while measuring top surface.
Note: Linear probe is not included.

Punch unit for Z-distance, Macro

D-20198-ZXX

Tool to establish Z-distance in combination with either 3Refix or Matrix 142 pallet. This unit requires additional tool. It is possible to apply electrical or mechanical indicators while measuring top surface. Note: Linear probe is not included.