Tooling for wire EDM

3R-272HP

For manual mounting of SuperVice, a holder or a fixture in the WEDM system. Note: All holders including HP can be mounted. Also fits the ICS system if the clamping jaw (17850-00) is changed.

3R-262HP

For mounting SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.

3R-266.4

For manual mounting of SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.

3R-266.5

For mounting SuperVice, a holder or a fixture in the Macro system. Note: All holders including HP can be mounted.

3R-282.12HP

For mounting Magnum holders in the MacroTwin system. Note: All holders including HP can be mounted.

3R-266.12HP

For manual mounting of Magnum holders in the MacroTwin system. Note: All holders including HP can be mounted

3R-228J

Stone with three ground faces, a reference element and a clearance stone. Together with a surface plate and a dial indicator, 3R-228J is an excellent presetting tool for a modest outlay.

3R-201J

Basic element for 3D accessories.

3R-204

Can be turned upwards or downwards when mounting on 3R-201J.

3R-223

Used where vertical or horizontal displacement of workpiece or accessory is necessary.

3R-203.66

Swivelling element with manual Macro chuck to be mounted onto a Macro chuck. Mecanical locking of the set position. Vernier scale for quick setting in 0.1-degree steps. Note: For angle setting sine ruler 3R-216.6 and gauge block are recommended.

3R-223.3

Used where vertical or horizontal displacement of workpiece or accessory is necessary.